Kikusui KHA1000, Руководство по эксплуатации, Страница: 173 / 274

KHA1000
6-17
6
V
o
lta
g
e C
h
an
g
es
a
n
d
F
lu
ctu
atio
n
s a
n
d
F
lic
ke
r T
es
t
9.
If the impedance is set, select menu F1 key (OK).
Selecting the menu F2 key (Cancel) ignores the presence of impedance. To start the
test, press the START key again.
The test is started. The test conditions display in the view changes from “Setting” to
“Test.”
The remaining time of the test is displayed.
The progress bar in the display extends from left to right. When it reaches the right
end, the test is finished.
During the test, the Vf-Observation and Analysis display (Vf-VIEW) appears.
Observation can be made in the display that was set in Step 7.

Finishing and judging the test
When the measuring time runs out, the buzzer sounds and the test is finished. An
ending dialog box is displayed. The test status display shown in the display changes
to “Analysis” and the progress bar in the display moves to the right end.
The ending dialog box shows “PASS,” if the
final test result is acceptable. The dialog
box shows “WARN,” if the final test result is acceptable but the margin is exceeded.
The dialog box shows “FAIL,” if the final test result is not acceptable. The color of the
progress bar is green for PASS, yellow for WARN, and red for FAIL.
If the d measuring method is “Pst Auto,” and if a steady state is not entered at least
two times within the time of one segment, a dialog box “d measurement of a
segment without a steady state was not performed” is displayed.
From analysis to saving test results, and printing reports
10.
Press the menu F1 key (OK).
The test ending menus are displayed and the buzzer stops.
The test ending menus include: F1 Save, F2 Report Print, F3 Exit, F4 Analysis
(VIEW), and F5 AC Pow. OUTPUT OFF.
Fig.6-6 Test ending menus F1 to F5
F1
F2
F3
F4
F5
F6