Kikusui KFM2151, Руководство по эксплуатации

Страница: 51 / 112

KFM2151
3-17
Operation
Clearing alarms
This section explains the procedure to clear the alarm on each channel and the
procedure to clear the alarms collectively on all channels.
The procedure on how to clear an alarm on a single KFM2151 is explained below.
Clear the alarms on each unit also when using multiple KFM2151s.
If the alarms of all channels are cleared, the OVP LED and UVP LED turn off. If
you do not eliminate the cause of the alarm, the alarm will occur again when you
perform scanning.
Clearing the alarm by selecting the channel
1.
Check that the KFM2151 is in monitor mode.
If the CHANNEL display or VOLT/TERM display is blinking, press the MON key.
2.
Press the IMP/ V OLT key to select v oltage.
The VOLT LED illuminates. The IMP LED and VOLT LED illuminate alternately
each time you press the IMP/VOLT key.
3.
Check the channel n u m b er on w hich the alarm occ u rred.
The monitor LED of the corresponding channel is illuminated in red.
4.
Press the and keys or SHIFT+ and keys to select the
channel n u m b er.
5.
Press the ALM CLR key.
The alarm on the selected channel is cleared. The monitor LED turns green.
Clearing the alarm on all channels
1.
Check that the KFM2151 is in monitor mode.
If the CHANNEL display or VOLT/TERM display is blinking, press the MON key.
2.
Press the IMP/ V OLT key to select v oltage.
The VOLT LED illuminates. The IMP LED and VOLT LED illuminate alternately
each time you press the IMP/VOLT key.
3.
Press the SHIFT+ALM CLR key.
All alarms are cleared. The monitor LEDs of all channels on which alarms occurred
turn to green.