Kikusui KFM2151, Руководство по эксплуатации

Страница: 50 / 112

3-16
KFM2151
Operation
3.10 Alarms
This section describes the display when alarms occur, and the procedure to clear
alarms.
Alarm display
When an alarm occurs while scanning voltage, the monitor LED illuminates as
shown in Table 3-6.
Ta b le 3-6 LED display w hen alarms occ u r
If an alarm occurs while monitoring the impedance, the OVP LED or UVP LED and
the corresponding monitor LED illuminate in red. The LEDs illuminate even when
the corresponding channel is not scanning the impedance.
The LED remains illuminated until the alarm is cleared. If you do not eliminate the
cause of the alarm, the alarm will occur again when you clear the alarm and perform
scanning.
LED Alarm Description LED Display
Monitor LED
There are channels on w hich alarms are
occ u rring.
The corresponding channels
ill
u minate in red.
O V P LED
There are channels on w hich O V P alarms
are occ u rring.
Ill u minates in red.
U V P LED
There are channels on w hich U V P alarms
are occ u rring.
Ill u minates in red.