Kikusui KDS6-0.2TR, Руководство по эксплуатации

Страница: 39 / 60

KDS6-0.2TR Remote Control 35
Fig. 4-3 Maps of status byte and service request enable registers
*CLS
Clears error registers and status byte registers excluding the RQS bit (bit 6). How-
ever, when a factor such as OCP or the like is ongoing, the relevant bit is set imme-
diately after clearing.
The RQS bit (bit 6) of a status byte register is cleared when serial polling is exe-
cuted or the power is turned off and on again.
Program message
• Syntax
Command message:
*CLS
SRQ has
occurred
*STB
status byte register
Bit 7 6 5 4 3 2 1 0
Signal name PON RQS ESB MAV ERR – – OCP
Bit weight 128 64 32 16 8 4 2 1
*SRE
service request enable register
Bit 7 6 5 4 3 2 1 0
Signal name – – – – ERR – – OCP
Bit weight 128 64 32 16 8 4 2 1
PON: Setting of POWER ON SRQ (not in use) ERR: ERROR register status summary
RQS: Request service Not in use
ESB: Event status summary (not in use) Not in use
MAV: Message ready (not in use) OCP: OCP status summary
+
x
x
ERR: The bit becomes “1” if a command error or data section error occurs.
OCP: The bit becomes “1” if OCP is activated in any of Channels 1 to 3.
RQS: This bit becomes “1” when the bit registered in the service request enable
register becomes “1.”
Cleared when serial polling is performed.