Kiepe Elektrik SEG, Руководство по эксплуатации

Страница: 42 / 72

42
SEG Operating Instructions
5 Mounting and dismounting
5.5.2 Detaching the electrical connections
1. Remove the screwed cable gland nut ( 11 ).
2. Remove the cable in the pull-rope emergency stop
switch from fastening clamp ( 14 ) and remove the
cable tie if applicable (see Fig. 5-6) .
Note!
To mount a new pull-rope emergency stop
switch or a repaired pull-rope emergency stop
switch, we recommend that the connections be
labeled with the connection designations for the
pull-rope emergency stop switch before the
connection cables are disconnected.
3. Disconnect the connection cable between the safety
and control circuits and the switching elements ( 5 , 6 )
and if applicable, disconnect the connection cable
for the signal lamp (
12 ) as described in Section 4.2:
„Electrical connection“, page 24 (see Fig. 5-6) .
4. Disconnect the protective conductor on the protec-
tive conductor connection M4 ( 8 ).
5. Remove the cable from screwed cable gland ( 11 ).
Fig. 5-6: Electrical connections
X1 X2
13 14
33 34
53 54
21 22
41 42
61 62
X1 X2
1
2
6 (N/O contact,
control circuit)
5 (N/C contact,
safety circuit)
12
Pull rope side
14 12
8