A
Page 4 / 8
Commissioning
IT554
Datasheet 4.30-50.554-11-EN
Requirements
For the initial installation of the firmware, you will need the BIN file from the generated ZIP file. (See
the TechnoWay Configurator user manual.)
The TRX file is used to update the firmware. (See the TechnoWay Configurator user manual.)
►
Unpack the ZIP file.
Initial firmware installation of the IT554 VPN Router
Initial firmware installation
During the initial firmware installation, the pre-installed firmware is replaced by the new firmware.
►
Ensure that all routers have been labeled.
►
Start the browser.
►
Enter the IP address of the router in the address field of the browser: “http://192.168.1.1”.
►
Press the ENTER key.
The firmware starts and opens the logon dialog.
►
Skip over the “User name” text box. It remains empty.
►
Enter the password “admin”.
►
Click the “OK” button.
The start screen of the firmware is displayed.
►
Select the “Administration” menu.
►
Select the “Update firmware” menu.
The selection dialog for the upgrade file is displayed.
►
Click the “Browse” button.
►
Select the BIN file.
►
Click the “Update” button.
The firmware installation is carried out.
NOTE
In the “Update successful” window, do
not
click the button “Continue”. Since the IP address of the
VPN router was changed by the installation, this results in a browser error message.
Restarting the VPN router
After successful installation, the router restarts. The “Power” LED flashes during startup. The new IP
address is activated. After about two minutes, the restart is complete. When the “Power” LED stops
flashing, the firmware is installed.
►
Switch off the router for at least three seconds. Alternatively, you can remove the network cable
from the LAN port.
►
Switch on the router or insert the network cable back into the LAN port.
The computer recognizes the new IP address and establishes the connection to the router.
NOTE
Check the connection to the new IP address of the router by entering the IP address in the address
field of the browser.
NOTE
Label the router with the configuration ID and LAN IP.
