A
Page 7 / 8
Datasheet 4.65-30.013-11-EN
GLT-D005-TFA4
Commissioning
Issue 2017-03-30
Setting Up the Printer for Consecutive Log File Printing
With the BMS program MALFUNCTION MESSAGE DISPLAY, malfunctions occurring in building
services are displayed as malfunction and system error messages. You can print the event logs out
if the printer is configured for consecutive log file printing.
To configure the printer for consecutive log file printing, rather than making the settings outlined in
the previous two sections, make the following settings in the “BMS configuration” window:
►
In “BMS configuration,” select “Settings.”
►
Select “Malfunction messages” and set the “Type of malfunction message print out” to
“Postscript” and “Collected” or “Individual” in the “Print” tab.
If “Postscript” and “Collected” are activated, the malfunction messages are only output once
a page is full of malfunction messages. You can enable the “Display outgoing malfunctions
with message text” option.
If “Postscript” and “Individual” are activated, one malfunction message is output per page.
The “Display outgoing malfunctions with message text” option is suppressed.
►
Save the configuration with [OK].
►
In order to activate consecutive log file printing, check the “Consecutive log file print, direct
printout” check box in “Printer configuration” and click [OK] to confirm.
Consecutive log file printing is activated.
You can adjust the print image using the printer-specific settings. The printer driver works on the
assumption that the pages do not have margins. You must therefore set the print image for the
specific printer under “Printer configuration” > “Settings” > “Print settings”
►
First of all, print a test page.
►
Then set the margins.
►
Click [Default] to reset the page margins to the default settings.
