A
Page 4 / 8
Commissioning
GLT-D005-TFA4
Datasheet 4.65-30.013-11-EN
Issue 2017-03-30
Manual configuration
In addition to the automatic IP address configuration, you can also assign the printer IP address
manually. To do so, you must know the printer IP address.
Since the printer does not have a preset IP address and only the internal IP address “0.0.0.0” is set
when it is in its initial state, an IP address must be assigned via DHCP beforehand and read from the
printout of the network configuration page.
You can use the integrated Web server on the printer to configure its IP address manually. Proceed
as follows:
►
To access the integrated Web server on the printer, enter the printer IP address in the address
bar of your browser.
Select the following settings:
►
Select the “Network” tab.
►
In the “Wired (802.3)” section, select the “IPv4” menu item.
►
Select “Manual IP Address.”
►
Enter the IP address, subnet mask and default gateway in the relevant fields.
►
Click [Accept].
The current connection to the Web server is lost.
►
Check the change by entering the new IP address in the address bar of your browser.
The browser configuration page is displayed.
►
If the printer cannot be accessed from the browser, press both the [Cancel] and [Wireless] buttons
on the printer simultaneously for at least three seconds.
The printer network configuration is then reset to its initial state.
►
Repeat the manual configuration of the network.
Retrieving Configuration Data
Printer operator panel
You have to add the printer’s IP address to the BMS configuration. The IP address is also required
to add the printer to the network.
You can retrieve the IP address using the printer’s operator panel.
►
Press the [Resume] and [Wireless] buttons on the printer simultaneously.
or
►
Print the [Cancel] button on the printer for 3 seconds.