SWRA406 - ©2012 Stillwater Designs
9-27-12
Page 4 of 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Subwoofer Input Connection for Premium Audio vehicles with factory eight-channel amplifier installed
21.
Locate the 16 pin connector on the amplifier under the steering column. Find the green/brown stripe
wire and the gray/brown strip wire in this connector and install one of the self stripping t-tap
connectors on to each wire. Lay the wire in the open channel, fold the connector body over and
squeeze with a pair of pliers until connector snaps shut. Fig. 10
22.
Connect the green wire of the subwoofer harness to the gray/brown strip wire. Connect the brown
wire of the subwoofer harness to the green/brown stripe wire.
23.
Install the supplied two pin connector by inserting the terminals on the end of the power wire into the
back of the connector until it clicks and locks. Either wire can go in either hole. Fig. 11
24.
Depress the blue terminal retainer down in the center of the connector.
25.
Using a 10mm socket and ratchet remove one of the factory ground nuts on the driver’s side kick
area. Connect the black ground wire, reinstall the nut and tighten. Fig. 12. Torque to 8Nm.
26.
Run the wire harness along the floor under the rear seats to approximately the middle of the vehicle
and pull the end of the harness under the seat to the cargo area. Fig. 13
27.
Set the subwoofer in place and connect the wire harness.
28.
Rotate the rear seat back until it is nearly vertical. While holding the seat back with one hand, slide
the enclosure back until the hooks on the bracket are centered under the anchor points at the
bottom of the seat. Slowly rotate the seat back toward the rear of the vehicle until it locks into place.
Fig. 14
