PROGRAMMING HD RADIO
NOTE:
It is necessary to re-fl ash your HD radio before installation of this kit. If you do not have the Techno Research Centurion program soft-
ware you may purchase a Kicker TRHDP Radio Flash Programmer.
GETTING STARTED
1. Remove the seat and disconnect both positive and negative battery terminals.
2. Remove the windshield and outer fairing.
a. Once the windshield screws are removed, gently pull off the top vent/cowl piece. There are two plastic retainer clips that hold it on.
b. Remove your stock speaker grilles. Push them out from the inside of the fairing. They are fastened with a plastic retainer clip.
Fig 1.
c. Unplug the turn signals.
Fig 2.
d. Remove the lower T25 fasteners holding the air defl ectors to the inner fairing.
Fig 3.
e. Remove the 3/16” allen bolts holding the turn signals to the inner fairing.
Fig 4.
f. While holding the fairing, carefully remove the two T30 bolts behind the speaker grilles to remove the outer fairing and set aside.
Fig 5.
3. Remove the fuel tank.
a. Remove the console.
b. Unplug the fuel fi tting on the left side of the tank.
c. Remove all four mounting bolts and carefully lift the tank off the bike and set aside.
4. Remove wiring caddy cover.
a. Carefully release each tab along the caddy until it lifts completely.
Fig 6.
SPEAKER INSTALLATION
5. Remove your stock speakers and replace them with your new PSC652 speakers in the kit.
a. Install the provided speaker ring adapter onto the speaker pod.
Fig 7.
b. Install the speaker into the pod and fasten with the original speaker screws.
Fig 8.
AMP INSTALLATION
6. Remove the radio.
a. Unplug the four connectors on the back of the radio.
b. Remove the four allen head bolts holding the radio to the chassis.
c. Gently remove the radio from the chassis.
7. Install the PXA300.4 amplifi er onto bracket with supplied hardware.
Fig 9.
a. Slide the end of the amplifi er with the power connector port into the bracket and fasten with supplied hardware.
b. Install the bolts from the bottom and fasten the locknuts onto the amplifi er.
8. Carefully install bracket/amplifi er assembly onto radio chassis by installing the assembly through the radio face port in the fairing and sliding
the tabs of the bracket over the chassis.
Fig 10.
a. The amp bracket assembly mounts under the radio.
HARNESS INSTALLATION
9. Plug the harness into the amplifi er and route speaker wires to their respective connectors.
Fig 11.
a. Separate the speaker connectors and plug in the amplifi er harness to each speaker.
46HDR154
Motorcycle Audio Kit Installation Guide for
Harley Davidson
®
Road Glide (FLTR) 2015–Newer
Package Contents:
(1) Install Guide
(1) Wiring Harness
(4) Black Cable Ties
(2) 6-1/2” KICKER Speakers
(2) 8-32 x 1/2” Button Head Bolts
(1) Amplifi er Mounting Bracket
(1) 75W x 4 KICKER Amp
(2) 8-32 Nylock Nuts
(1) Dummy Load Plug
Important: Over-tightening mounting fasteners may result in damage to your motorcycle. Please refer to your service manual for proper
procedures and torque specifi cations. KICKER is not responsible for damage resulting from improper installation techniques. This kit
may not
be compatible with some aftermarket head units.
FRONT KIT PROGRAMMING WITH KICKER TRHDP
Follow instructions included with KICKER TRHDP
FRONT & REAR PROGRAMMING WITH KICKER TRHDP
Follow instructions included with KICKER TRHDP
