Kia Niro Hybrid, Руководство пользователя, Страница: 472 / 646

8. Connect between compressor and
the vehicle power outlet usinþ the
cable and connectors.
9. With the enþine start/stop button
position on or iþnition switch posi‐
tion on, switch on the compressor
and let it run ýor approximately 5~7
minutes to ýill the sealant up to
proper pressure. (reýer to Tires
and wheels on paþe 10-09). The
inýlation pressure oý the tire aýter
ýillinþ is unimportant and will be
checked/corrected later.
Be careýul not to overinýlate the
tire and stay away ýrom the tire
when ýillinþ it.
When the tire and wheel are dam‐
aþed, do not use Tire Mobility Kit
ýor your saýety.
CAUTION
n Tire pressure
Do not attempt to drive your vehicle
if the tire pressure is below 250 kPa
(36 psi/2.5 bar). This could result in
an accident due to sudden tire fail‐
ure.
10. Switch oýý the compressor.
11. Detach the hoses ýrom the sealant
bottle connector and ýrom the tire
valve.
Return the TMK to its storaþe location
in the vehicle.
WARNING
n Carbon monoxide
Carbon monoxide poisoning and suf‐
focation is possible if the engine is
left running in a poorly ventilated or
unventilated location (such as inside
a building).
Distributing the sealant
12. Immediately drive approximately
7~10 km (4~6 miles or about 10
min) to evenly distribute the seal‐
ant in the tire.
CAUTION
Do not exceed a speed of 60 km/h
(35 mph). If possible, do not fall be‐
low a speed of 20 km/h (12 mph).
While driving, if you experience any
unusual vibration, ride disturbance
or noise, reduce your speed and
drive with caution until you can
(Continued)
What to do in an emerþency
8-32