background image

Assemble units as described herein only. To do otherwise 
may result in instability. All screws, nuts and bolts must be  
tightened securely and must be checked periodically after  
assembly. Failure to assemble properly, or to secure parts 
may result in assembly failure and personal injury.

Assembly Instructions

U-Series

®  

Pedestal 

Worksurface Supporting Pedestal with Panel Supporting Bracket

January 2016

Removing Drawers

Note: 

To ease the assembly of 

support brackets to cabinets and 

cabinets to worksurfaces, all file 

drawers should be removed.

1. Empty the contents of file drawers 

and open drawer until suspension 

is fully extended (Figure 1).

2. Using a slot screwdriver, place 

tip between the drawer body and 

the suspension, near the slip 

connection (Detail A). 

3. Rotate the screw driver to pry the 

glide away from the drawer body, 

while pressing up on the bottom of 

the drawer (Detail A). 

4. The drawer will now slip free from 

the rear connections by pulling 

the drawer evenly at a slight angle 

upwards (Figure 1). 

drawer

suspension

slip

connection

drawer

bottom

drawers

pedestal

Detail A

Figure 1

Содержание U Series

Страница 1: ...ly of support brackets to cabinets and cabinets to worksurfaces all file drawers should be removed 1 Empty the contents of file drawers and open drawer until suspension is fully extended Figure 1 2 Using a slot screwdriver place tip between the drawer body and the suspension near the slip connection Detail A 3 Rotate the screw driver to pry the glide away from the drawer body while pressing up on ...

Страница 2: ...abinet for cosmetic integrity and safe installation of the worksurfaces Using a small piece of double sided tape at the top and bottom of the bracket to hold it in place can aid in alignment of the supporting bracket 2 Using the four 10 16 x 1 2 self drilling sheet metal screws provided carefully secure the panel supporting bracket to the cabinet Figure 2 or 3 Note For right hand installations ali...

Страница 3: ...spacer with the right side of the cabinet with the studs facing left Figure 4 For left hand installations flip the spacer over and align the bracket on the left side of the cabinet with the studs pointed right Figure 5 Important Care should be taken to ensure that the spacer is aligned well with the top and side of the cabinet for cosmetic integrity and safe installation of the worksurfaces Using ...

Страница 4: ...ke care to not over tighten screws Figure 6 Figure 6 pedestal adjustable glides panel supporting bracket panel glide cantilever bracket worksurface Unite panel hanger bolt thumb screw Note If installing a double pedestal not shown no holes have been pre drilled into the underside of the worksurface for installation Once the double pedestal is aligned square use the pedestal mounting holes as a tem...

Отзывы: