background image

Assemble units as described herein only. To do otherwise 
may result in instability. All screws, nuts and bolts must be  
tightened securely and must be checked periodically after  
assembly. Failure to assemble properly, or to secure parts 
may result in assembly failure and personal injury.

Required Tools

•  Phillips screwdriver or #2 Phillips 

driver bit and electric drill

Connecting Tables Assembly

Note:

 Multiple seating must 

be joined together first, before 

assembling connecting tables. 

Once assembled together, do not 

move seating units that exceed 

three seating positions without the 

assistance of a second person, as 

damage may occur to the assembly. 

1. Carefully un-pack all contents 

from packaging. Arrange seating 

to the approximate location per the 

space-planning layout, leaving a gap 

between the seats intended to join 

with tables (Figure 1). 

Note:

 Center connecting tables 

and 45 degree connector tables 

are supported by the two adjoining 

seating units using connecting table 

brackets. End tables are supported 

by one adjoining seating unit with a 

connecting table bracket, 90 degree 

connector tables are supported by 

two adjoining seating units using 

connecting table brackets and both 

table units require the installation of 

a leg for additional support. If center 

connecting tables or 45 degree 

connector tables are to be installed, 

proceed to “Center Connecting 

Table & 45 Degree Connector Table 

Assembly” instructions on this page. 

If ONLY end or 90 degree connector 

tables are to be installed, proceed 

“Connecting End Table & 90 Degree 

Connector Table Assembly” 

instructions on the next page.

Assembly Instructions

Soltice

®

 Metal

Connecting Tables

August 2019

Center Connecting Table &  

45 Degree Connector Table 

Assembly

1. Move two multiple seating 

units close enough together so 

the tabletop to be installed can 

be supported by pre-installed 

connecting table brackets of both 

seating units (Figure 1). 

2. Place the center connecting table 

(Figure 1) or 45 degree connector 

table (Figures 1 & 2) onto the two 

table brackets. Align the pre-drilled 

holes of the underside of the tabletop 

with the mounting holes of each 

table bracket and secure using six 

#10 x 

3

/

4

” wood screws per bracket 

(Figures 1 & 2). 

Figure 1

connecting

table bracket

#10 x  / ”

Phillips wood

screws

3

4

center

connecting

table

45 degree
connector

table (inside)

Figure 2

45 degree
connector

table (outside)

connecting

table bracket

#10 x  / ”

Phillips wood

screws

3

4

Отзывы: