background image

1. Carefully unpack all parts from

shipping container and place paper
sorter onto a soft, protective 
surface.  Identify parts below from
the “Hardware Pack” diagram &
Figure 4.

2. Prior to installation of paper sorter,

certain components must be
removed from overhead cabinet, if
present. Remove optional task light
from under cabinet shelf. Remove
valance from under overhead 
cabinet (Figure 1) and retain to
reinstall after step 6.

3. If required, place the optional 

tackboard into position (Figure 2)
at this time, prior to installing paper
sorter. Later, in step 4, six #8 x 1

1

/

4

"

wood screws will be used to secure
6” bracket to back panel through
the optional tackboard. 

Caution:

That is the only use for #8 x
1

1

/

2

" screws.

4. Position the paper sorter assembly

up under the lower shelf of the
overhead cabinet as illustrated
(Figure 3) and mark a line onto the
shelf underside at the center divider
location to indicate where the 
center bracket will be installed.
Remove the paper sorter assembly
and position small, 1

1

/

2

" bracket

onto the line to mark, then pre-drill
the mounting holes to underside of
cabinet shelf (take care not to drill
to deep). Attach the small 1

1

/

2

"

angle bracket to the underside of
the shelf using #8 x 

5

/

8

" wood

screws (Figures 3 & 4).

Assembly Instructions

Aristotle™ Casegoods

O v e r h e a d   Pa p e r   S o r t e r

March 2008

Assemble units as described herein only. To do otherwise
may result in instability.  All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and injury.

1330 Bellevue Street • P. O. Box 8100 • Green Bay, WI  54308-8100 • Tel 1-800-424-2432 • www.ki.com 

© 2008 KI All Rights Reserved • Litho in USA • Code KI-62016/HT/PDF/0308 

7HP30 - Hardware Pack

6” Angle
Bracket

28

6

1

4

*Use only if tackboard is installed.

#

8

 x 

5

/

8

” 

Wood S

cr

ew

s

#

8

 x 1

1

/

4

” 

Wood S

cr

ew

s

*

1

/

2

” Angle

B

r

a

c

ket

valan

c

e

valan

c

e atta

c

hment

b

r

a

c

ket

Figure 1

ta

c

kboa

r

d

(optional)

Figure 2

unde

rs

ide of 

s

helf

c

ente

r

 divide

r

Figure 3

pape

r

 

s

o

r

te

r

 a

ss

embl

y

Figure 4

Отзывы: