Ki Mobility ROGUE XP, Инструкция пользователя и гарантия

Страница: 30 / 76

29
IV. WHEELCHAIR USE & CONFIGURATION
S. Dynamic 5th Wheel
If the Dynamic 5th Wheel caster touches the ground, it is possible that the large rear wheels
might not touch the ground. Adjust the height of the caster to prevent the rear wheels from not
touching the ground and consider a higher position if being used outdoors or on uneven
surfaces.
How to Insert and Remove the Dynamic 5th Wheel
1. To remove, pull the release knob (Fig. 17:A) to disengage the locking pin and slide the
assembly out of the tubular receiver.
2. To insert the assembly, pull the release knob (Fig. 17:A) and insert the assembly into the
tubular receiver (Fig. 17:B).
3. Rotate the assembly in the receiver to align the slot (Fig. 17:C) and the cross pin (Fig. 17:D).
4. Release the knob (Fig. 17:A).
How to Adjust the Position from the Floor
1. Loosen the 6mm bolt in the clamping ring (Fig. 18:A).
2. Grasp the caster fork assembly and move up or down to the desired position. Take care to
not rotate the caster stem within housing while repositioning.
3. Retighten the 6mm bolt in the clamping ring (Fig. 18:A).
A
B
C
D
Fig. 17
A
Fig. 18