12
Backrest Assembly
NOTE: It is important that during the backrest mount installation procedures both sides of your
chair are set up the same. Take care to move assembly equal distance on each side. Each click is
equivalent to ½". Only once the assembly is in the desired location should you tighten any hardware
to secure the position.
1. Remove current backrest mount on chair.
2. Install backrest mount assembly (B) onto frame tube with two bolts (C) and two nuts (A) using a 5mm
Allen wrench and a 10mm wrench. Position on tube is based on desired seat depth. Repeat on
opposite side.
3. Install the backrest onto the backrest mount and secure with two bolts (E), two washers (D), two
saddles (B) and two nuts (A) using a 4mm Allen wrench and a 10mm wrench. For changing the angle of
the backrest, please refer to the Backrest Angle Adjustment section in your Owner Manual. Repeat on
opposite side.
NOTE: For an offset backrest, two spacers (C) are added into the hardware.
A
B
C
C
(Offset
Only)
D
E
A
B
