Keystone KSTAP12A, Руководство пользователя

Страница: 18 / 39

CARE AND MAINTENANCE
CARE AND MAINTENANCE
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, thinner or other chemicals to clean
the unit.
3) Do not wash the unit directly under a tap or using a hose.
It may cause electrical danger.
4) If the power cord is damaged, it should be repaired by
manufacturer or its agent.
IMPORTANT:
1. Air filter
- Clean the air filter at least once two weeks to prevent
inferior fan operation because of dust.
-
This unit has two filters. Grasp the upper filter tab(Fig.22),
pull the filter out. Remove the lower filter by loosening the
screws, take down the air inlet grille, then remove the air
filter as shown in Fig.23 & 24.
-
Wash the air filter by immersing it gently in warm water
(about 40 C/104 F) with a neutral detergent. Rinse the filter
and dry it in a shady place.
-
Insert the upper air filter from upward after cleaning, attach
the lower air filter on the air inlet grille, then install the grille
by using the screw.
Removal
Cleaning
Mounting
O O
2. Unit enclosure
- Use a lint-free cloth soaked with neutral detergent to clean
the unit enclosure. Finished by a dry clean cloth.
3. Unit idle for a long time
15
,,
- Remove the rubber plug at the back of the unit and attach
a hose to drain outlet
(See Fig.4 & 5).
- Remove the plug from the bottom drain outlet, all the water
in the bottom tray would drain out (See Fig.6).
- Keep the appliance running on FAN mode for half a day in
a warm room to dry the appliance inside and prevent mold.
- Stop the appliance and unplug it, wrap the cord and
bundle it with the tape(Fig.25). Remove the batteries from
the remote controller.
- Clean the air filter and reinstall it.
- Disconnect the exhaust hose and keep it safety.
. Place the open end of the hose
directly over the drain area in your basement floor
Fig.22
Ai r filt er
(s lide out)
Fig.23
Fig.25
R emove the
sc rew and
ta ke the air
inlet gril le
do wn
R emove the air filter
out from the grille
Fig.24
Band
Power cord