This information is subject to change without notice.
© Keysight Technologies 2014
Edition 3 September 2014
*Y1217-90001*
Y1217-90001
www.keysight.com
Страница 1: ...ument or chassis should always be mounted at the bottom of the rack 4 For maximum cooling and optimum rack thermal efficiency place the instrument or chassis with the greatest power consumption towards the top of the rack This promotes efficient cooling since heat rises when placed nearer to the top of the rack high power instruments will not unnecessarily heat other instruments However in doing t...
Страница 2: ... must be removed one on each side of the chassis Refer to Figure 1 Note that earlier chassis did not have these screws 4 Remove the four chassis feet by pulling out the small rubber insert on each foot and then removing the Phillips screw that attaches the foot to the chassis See Figure 1 5 Refer to Figure 2 Slide channel nuts over the rack holes to be used by the support rails The rails must be p...
Страница 3: ...the M9018A chassis into the rack until the rack mount front handle flanges are against the rack s vertical columns Secure the chassis to the rack using the adapter dress screws provided with the rack flange kit Figure 2 Center Holes of Rack Attaching Channel Nuts Important Install support rails with inner flange pointing downward Channel nuts on rack s inside vertical rails To prevent injury durin...
Страница 4: ...This information is subject to change without notice Keysight Technologies 2014 Edition 3 September 2014 Y1217 90001 Y1217 90001 www keysight com ...
