SENSe Subsystem
8
Keysight U2722A/U2723A Programmer’s Reference
47
SENSe:SWEep:TINTerval
Syntax
SENSe:SWEep:TINTerval <interval>, (@<ch>)
This command defines the time period between samples in milliseconds on
models that have measurement controls. Programmed values can range from
1 to 32767.
SENSe:SWEep:TINTerval? (@<ch>)
Queries the time interval set.
Parameters
Returned Query Format
<NR1>
The query command returns the time interval for each channel specified. The
returned value is the time period in milliseconds.
Examples
The following command specifies a time interval of 10 milliseconds between
measurement points on channel 1.
SENS:SWE:TINT 10, (@1)
The following query returns the measurement time interval for channel 2.
SENS:SWE:TINT? (@2)
See Also
Item
Type
Range of values
Default value
<ch>
NR1
1 through 3
Required parameter
<interval>
NR1
1 to 32767
Required parameter
Содержание u2722a
