Introduction to Programming
1
Keysight U2722A/U2723A Programmer’s Reference
17
Address/Channel List Parameter
There are two ways to specify the U2722A/U2723A address or channel list
parameter. To specify a single channel, use the following syntax.
(@<ch>)
For example,
CURR 0.02
,
(@1)
, where
(@1)
specifies channel 1.
To specify a single address, use the following syntax.
(@<address>)
For example,
CONF:SSI SLAV
,
(@1)
, where
(@1)
specifies address 1.
To specify more than one address, the following syntax must be used.
(@<address>[,<address>])
NOTE
– The command
CONFigure:SSI
is the only U2722A/U2723A command that
uses the range of address list.
– When adding a channel list parameter to a query, you must include a space
character between the query indicator (?) and channel list parameter.
Otherwise error
–103, “Invalid
separator”
will occur.
Содержание u2722a
