Keysight MultiScope UXR Series, Руководство по конфигурации оборудования

Страница: 5 / 30

Keysight UXR-Series MultiScope Hardware Configuration Guide 5
In This Guide
This guide describes the equipment required to configure MultiScope systems and
shows you how to set up and connect the equipment:
•
Chapter 1 , “UXR-Series MultiScope System Requirements,” starting on page 9 .
Depending on the UXR-Series oscilloscope bandwidths and number of channels
required, you will use one of the configurations shown in the following table.
After you have set up and connected the MultiScope system, see:
•
Chapter 4 , “Next Steps,” starting on page 23 .
See Also • The Infiniium UXR-Series oscilloscope software’s online help for information on
using the MultiScope Hosted Instruments software.
# of channels
required (4-ch
oscilloscopes)
# of channels
required (2-ch
oscilloscopes)
Configuration required See:
5-8 3-4 2-oscilloscope configuration Chapter 2 , “Two-Oscilloscope System,” starting on
page 11 (that can be expanded later).
9-20 5-10 3-to-5-oscilloscope
configuration (1 rack)
Chapter 3 , “Three- to Five-Oscilloscope Systems,”
starting on page 17.