Keysight M9514A, Руководство по подготовке места и установке

Страница: 29 / 46

Keysight M9514A Site Preparation and Installation Guide 31
Procedure Rack Mount the Chassis
Procedure
1
The M9514A AXIe chassis has four rubber feet on the bottom of the chassis
that must be removed prior to rack mounting. Never lay the chassis on its
front or back. Remove all AXIe modules from the chassis before removing the
rubber feet.
2
Lay a blanket on the floor or workbench to protect the chassis. Carefully lay
the chassis on one side on the blanket. Use a #2 Phillips screwdriver to
remove the rubber feet. Store the feet and screws in case you should ever
need to replace them.
3
Carefully set the chassis upright again.
4
Refer to Figure 6. Position the rack mounting support rails (E3664AC) on the
rack’s vertical columns where the chassis is to be mounted. Align the adapter
holes over the “top” holes of the EIA rack units. On Agilent racks, the bottom
of the rail should align with an arrow on the front of the rack mounting frame.
Do not use the support rails supplied with the rack.
5
Slide clip-on sheet metal nuts over the rack holes to be used by the support
rails.
Figure 5 Remove the four rubber feet prior to rack mounting the chassis.