Keysight M9514A, Руководство по подготовке места и установке

Страница: 19 / 46

M9514A AXIe Chassis 14-Slot
Site Preparation and Installation Guide
21
3 Connect the Chassis to the AC
Power Line
It is the customer's responsibility to:
- Prepare the site with adequate AC power for the system
- Provide a power cord (from the AC line mains disconnect to the chassis)
– Four power cords are available from Agilent for the M9514A:
-
Y1235A for 1-phase, no Neutral, 250VAC, NEMA L6-30P, 2.5 M (8.2 feet)
1
-
Y1236A for 3-phase, Wye with Neutral, 240/415VAC, IEC 60309, 2.5 M
(8.2 feet)
1
-
Y1237A for 3-phase, Delta/Wye, no Neutral, 250VAC, NEMA L15-30P, 2.5
M (8.2 feet)
1
-
Y1238A for 3-phase, Wye with Neutral, 240/415VAC, Stripped End, 2.5 M
(8.2 feet)
1
Refer to Appendix A , “Power Cords,” starting on page 43 for detailed
information about the Agilent power cords.
– An IEC 60309 (3P+N+E, 6H Red) plug is installed on the chassis at the
factory. This can be used for connecting the above Agilent power cords.
- Connect the system to the AC power source.
Those responsible for the proper design and installation of the power distribution
system must have a thorough knowledge of the appropriate local and regional
electrical codes and the limitations of the power system.
1 These are the AC power cord ratings, not the AC power ratings for the M9514A chassis. The Agilent M9514A
chassis AC input is rated to 240 VAC line-to-line. See Appendix A for cord information.