Keysight M8100A Series, Руководство по началу работы

Страница: 39 / 46

Keysight M8100A Series Arbitrary Waveform Generators Getting Started Guide 39
Basic Setup for M8100A 2
software and compared to the module’s serial number. If the PC Host ID
and serial number match, the EEPROM in the module is programmed and
the option is enabled. Even if the M8070B software license is transported
to another host computer, the module option will remain enabled.
The following procedure shows how to redeem and install a module
license.
1 Locate the Software License Entitlement Certificate (email or paper
copy).
2 Follow the instructions on the Software License Entitlement Certificate
to redeem your license.
3 You will receive a license file (in an email). The file has the suffix .lic.
4 Follow the instructions in the email to complete the installation of the
license file.
5 In the M8070B software interface, verify that the license has been
installed by selecting Utilities > Licenses then viewing the license
status in the Installed column.
Step 14 - Turning off the Chassis and Modules
Turn off the chassis and module in the following sequence:
1 Turn off the host computer. If you are using the Keysight AXIe
Embedded Controller module as the host computer, ensure that you
shut down the controller by executing the Windows shutdown process.
2 Turn off the chassis by pressing the chassis ON/STANDBY switch on
the front panel of chassis. Do not use the circuit breaker for routine
turn off. The module(s) are turned off automatically with the chassis.