Keysight E3631A, Руководство по обслуживанию, Страница: 103 / 131

Theory of Operation 4
Keysight E3631A Service Guide 99
Floating Logic
The floating common logic controls operation of the entire instrument. All output
functions and bus command interpretation is performed in the main controller
U17. The front panel and the earth referenced logic operate as slaves to U17. The
floating common logic is comprised of the main controller U17, custom gate array
U16, the program ROM U14, RAM U15, calibration EEPROM U18, and the 12 MHz
clock oscillator Y1 on the top board . Non-volatile EEPROM U18 stores calibration
constants, calibration secure code, and calibration count. Power-on reset is
provided to the main controller by the voltage regulator U1 on the top board.
The main controller U17 is a 16-bit micro controller. It controls such features as
receive and transmit serial port, timer/counter ports, an 8-bit pulse width
modulated DAC port, and selectable input 10-bit successive approximation a-to-d
convert ports. A conventional address/data bus is used to transfer data between
the main controller and external ROM and RAM. When the address latch enable
(ALE) signal goes high, address data is present on the address/data bus. ASIC
U16 latches the address data and decodes the correct chip enable (low true) for
external ROM and RAM accesses and for read/write accesses to the internal
registers of U16. The system memory map is shown below.
Program ROM U14 contains four 64k x 8 data banks of data. Banks are selected by
controlling A16 and A17 ROM address bits directly from the main controller port
bits.
Custom gate array U16 performs address latching and memory map decoding
functions as discussed above. In addition, U16 contains a variety of internal read/
write registers. The read (XRD) and write (XWR) signals transfer data out of and
into U16 when it is addressed. There are four internal registers in U16: an internal
configuration register, an 8 bit counter register, a serial transmit/receive register,
and an internal status register.
The counter register is used to capture the ADC slope count at the COMP input.
The COMP input functions as both a clocked comparator and the slope counter
input for the ADC. In both cases the counter register captures the lower 8 bits of a
0000
H
- 1FF7
H
U15 8k x 8 RAM
1FF8
H
- 1FFF
H
U16 Gate Array
2000
H
- FFFF
H
U14 Program ROM