Keysight 33210A, Руководство пользователя

Страница: 247 / 351

245
Chapter 4 Remote Interface Reference
Interface Configuration Commands
4
SYSTem:COMMunicate:LAN:NETBios {OFF|0|ON|1}
SYSTem:COMMunicate:LAN:NETBios?
Disables or enables the use of NETBios to automatically assign an IP
address to the 33210A for peer-to-peer naming on a private network that
uses the NETBios naming service. The factory setting is enabled (ON).
The query returns “0” (OFF) or “1” (ON).
• If you change the NETBios setting, you must cycle power on the
instrument to activate the new setting.
• The NETBios setting is stored in non-volatile memory, and does not
change when power has been off, or after an instrument reset (
*RST
).
SYSTem:COMMunicate:LAN:TELNet:PROMpt < string >
SYSTem:COMMunicate:LAN:TELNet:PROMpt?
Sets the command prompt seen when using a Telnet session to
communicate with the 33210A. The default prompt is “
33210A>
”.
• The 33210A uses LAN port 5024 for Telnet sessions.
• Telnet session can typically be started as follows from a host
computer shell:
telnet <IP_address> <port>
For example:
telnet 169.254.2.20 5024
To exit a Telnet session, press <
Cntr-D
>.
• The prompt is a quoted string of up to 15 characters.
• The command prompt is stored in non-volatile memory, and does not
change when power has been off, or after an instrument reset (
*RST
).
33210A users guide.book Page 245 Wednesday, July 16, 2008 11:16 AM