Keysight 33210A, Руководство по обслуживанию

Страница: 76 / 131

74
Chapter 4 Calibration Procedures
General Calibration/Adjustment Procedure
4
General Calibration/Adjustment Procedure
The following procedure is the recommended method to complete an
instrument calibration. This procedure is an overview of the steps
required for a complete calibration. Additional details for each step in
this procedure are given in the appropriate sections of this chapter.
1
Read “Test Considerations” on page 57.
2
Unsecure the instrument for calibration (see page 71).
3
Perform the verification tests, beginning on page 58, to characterize the
instrument (incoming data).
4
Press on the front panel.
5
Select the “Test / Cal” menu.
6
Select Perform Cal .
7
Enter the Setup Number for the procedure being performed. The default
setup number is “1” and, from the front panel, the number will increment
as the procedures are performed.
8
Select BEGIN .
9
For setups that require an input, adjust the value shown in the display
to the measured value and select
ENTER VALUE .
10
The setup will automatically advance to the next required value.
Note
To cancel the adjustment procedure, select CANCEL STEP . The display
will return to the setup number entry.
11 When finished, select END CAL .
12 Secure the instrument against calibration.
13 Note the new security code and calibration count in the instrument’s
maintenance records.