4
Using E4410 E-Series Power Sensors
152
Keysight N1913/1914A User’s Guide
Now, set the frequency of the signal you want to measure. The power meter
automatically selects the appropriate calibration factor.
6
Press
. On dual channel meters select the required channel.
7
Use the
and
keys to highlight the
Frequency
value field and press
to display the
Frequency
pop-up. Use the numeric keypad to enter the
required value in the
Frequency
pop-up window.
Figure 4-3
Frequency pop-up
8
Confirm your choice by pressing
or
.
9
Press
key to close the
Channel Setup
screen.
Make the measurement now.
10
Connect the power sensor to the signal to be measured.
The corrected measurement result is displayed.
NOTE
You can reduce the steps required to carry out the zero and calibration
procedure as follows:
– Connect the power sensor to the POWER REF output.
– Press
and
. (For dual channel meters, press
,
or
as required).
Zero + Cal
Zero + Cal
Zero + Cal A
Zero + Cal B
MHz
GHz
Содержание 1914A
