U3020AS16
Instrument Settings
LAN Configuration Commands
IP Address Command
This command assigns a static Internet Protocol (IP) address for the U3020A.
Contact your network administrator for the valid IP address to use for your
instrument.
If you change the IP address, you must cycle power on the U3020A to activate
the new address.
Syntax
:
SYSTem:COMMunicate:LAN:IPADdress <address>
SYSTem:COMMunicate:LAN:IPADdress?
You can also queries the U3020A for the IP address it was assigned to.
Example
:
The following command sets the IP address:
SYST:COMM:IPAD 169.254.149.35
The following query returns the IP address currently being used by the
instrument (quotes are also returned).
SYST:COMM:LAN:IPAD?
Typical Response: "169.254.149.35"
Auto IP Address Command
This command disable or enable the use of Auto-IP standard to automatically
assign an IP address to the U3020A when on a network that does not have
DHCP servers.
Syntax
:
SYSTem:COMMunicate:LAN:AUTOip {OFF|0|ON|1}
SYSTem:COMMunicate:LAN:AUTOip?
Example
:
The following command disable the Auto-IP:
SYST:COMM:LAN:AUTOIP OFF
The following query returns the current Auto-IP setting:
SYST:COMM:LAN:AUTOIP?
Typical Response: 0
Keysight U3020AS16 User's and Service Guide
25