11
Quick Start Guide
Generating a Sweep Signal
Generating a Sweep Signal
To simplify the example, assume you wish to generate a RF
sweep signal with the characteristics of:
•
Frequency range from 1 to 2 GHz
•
Step sweep of 10 points
•
Dwell time of 500 ms for each step
Setting up a Step Sweep
Operation
Notes
1.
Press
hardkey
Sets the signal generator to its
factory-defined instrument state.
2.
Press
hardkey
Enables the submenu of sweep
softkeys.
3.
Press
Step Sweep
softkey
Enables the submenu of sweep
settings.
4.
Press
RF Start > 1 > GHz
Sets the step sweep start
frequency to 1 GHz.
5.
Press
RF Stop > 2 > GHz
Sets the step sweep stop
frequency to 2 GHz.
6.
Press
#Points > 10 > Enter
Sets the step point to 10 in the step
sweep.
7.
Press
More>Step Dwell>500>ms
Sets the dwell time to 500 ms for
each point in the step sweep.
Preset
Sweep
