Keysight Technologies M9336A, Руководство для стартапов

Страница: 30 / 51

Step 3B - Install the M9336A PXIe Module
a. While holding the module by the injector/ejector handle and making sure the
injector/ejector handle is pushed down in the unlatched (downward) position,
slide the controller module into chassis, using the slot guides (top and
bottom).
b. Sliding the module into position, when you begin to feel resistance, pull up on
the injector/ejector handle to fully inject the module into the chassis
backplane connectors.
c. Tighten the module retaining screws (top and bottom) and torque them to 5
Lb-In (0.57 N-m).
3. Connect peripherals (mouse, keyboard, and monitor).
Remote Controller
If your configuration contains a Keysight Cable Interface module, follow the
procedure below.
The following procedure addresses using a cabled PCIe interface
between the chassis and an external host computer. However, if you
intend to use a system module to control a subordinate downstream
chassis or RAID configuration:
– Install the module in an x8 hybrid slot in the PXIe chassis.
– Reverse the switch settings from those noted in this procedure: On the
module, set both the S301 switches to "Host" and set the S201 rocker
switch to the left-hand position. On the chassis backplane, set the
controller slot power-supply switch to the left.
AWG Startup Guide 30