Keysight Technologies M1740A, Руководство по началу работы

Страница: 16 / 39

16 Getting Started Guide
Quick Start
Initial Inspection
Initial Inspection
Inspect the shipping container and the cushioning material for signs of stress.
Retain undamaged shipping materials for future use, as you may wish to ship
the test set to another location or to Keysight Technologies for service. Verify
the contents of the container against the table below.
Shipping Problems?
If the shipping materials are damaged or the contents of the container are
incomplete:
— Contact the nearest Keysight Technologies office.
— Keep the shipping materials for the carrier’s inspection.
— If you must return a test set to Keysight Technologies, use the undamaged
original or comparable shipping materials. See “Returning Your Test Set for
Service” on page 37 .
Item Deliverable Description
Getting Started Guide (this
document)
Provides first-time power on
instructions, licensing
information, operating system
information, and general
hardware information.
Keysight M1740A mmWave
Transceiver
RF Cables
(One or more of
M1740-60006 and/or
M1740-60014; quantity
depends on options
ordered at time of
purchase)
In addition to IF and LO signals,
these cables carry control signals
and DC supply voltages from the
E7760B Wideband Transceiver
(M1740-60006 cable) or from the
E7770A Common Interface Unit
(M1740-60014 cable).
The M1740A is often used in conjunction with the E7760B Wideband Transceiver
or the E7770A Common Interface Unit, but those are separate purchase and are
not always shipped with the M1740A.