Conducting a Self-Test
Conducting a Self-Test
The purpose of this self-test is to verify that the unit functions correctly, in that it can self-calibrate and
communicate with the processor controlling it.
When the SFP is launched it will initiate a self-calibration which takes a little over 1 minute.
Verify that no error is shown in the lower left hand log area. The image below shows the desired result.
Figure 5 - Soft Front Panel (SFP) showing results of Self-Test
Agilent M9202A PXI Express 12-bit Wideband IF Digitizer Startup Guide
15
