Program and Operating Instructions
Heart Rate Control Instructions (MS4400HR)
HEART RATE PROGRAM MODE
The Heart Rate program is designed to keep your heart rate a desired level of “beats per minute” by
automatically adjusting the incline. For example, if you have programmed in a desired heart rate of 105
beats per minute and your heart rate is only 95 beats per minute (you must be wearing Heart Rate
Transmitter), the incline will automatically increase to intensify the work load, and increase you heart rate
to the 105 beats per minute you programmed.
If your heart rate is above your programmed amount of beats per minute the incline will automatically
decrease to lower your heart rate. You may at any time during the Heart Rate Program adjust/override the
speed and or incline by simply pressing the correct corresponding buttons. You may change your “Target
Heart Rate” at any time during the program by pressing the or TARGET – buttons.
♦
Plug into a standard wall outlet (110-Volt AC, 15-amp circuit). Insert the
Safety Key
into the treadmill
console
♦
Place the Heart Rate transmitter strap across chest against the skin. Stand on the treadmill and straddle
belt.
♦
Press POWER button. There will be an eight (8) second delay after pressing the POWER button before
data can be entered. The WORKOUT time window will flash. The “Heart” shape on the treadmill will
be flashing if the Heart Rate Transmitter is transmitting. Adjust the strap on the chest until the console
is picking up a signal.
♦
For Quick Start, press START/STOP button. Belt will begin to move after 4 seconds. Step on belt
slowly after the belt starts moving. Speed or incline may be adjusted by using the appro
(increase) or – (decrease) buttons. Heart rate will read out in the Incline window.
♦
To select the Heart Rate Control program, press the “Heart Rate Control” button.
♦
The incline window will flash “125”, which is the default program target heart rate.
♦
Adjust Target Heart Rate to desired level with the or – buttons.
♦
Press START/STOP button, or continue instructions below to program Time and Speed.
♦
You can now program the Time and Speed. The WORKOUT time window will blink. Use the SPEED/
TIME + or – arrows to select your workout time, then press the ENTER PROGRAM button. The
SPEED window will now be flashing. Using the same + or – arrows, select the maximum speed for
your workout, then press ENTER PROGRAM. To start, press the START/STOP button.
PAGE 14
