The ALLIANCE TREADMILL is shipped in four pieces, please see assembly instructions below. After opening
the box, remove any packing materials from the treadmill. Do not throw away any packing materials until the unit
is working properly. Place the base on a clean, level surface. Make sure the electrical cord will easily reach an elec-
trical outlet.
Figure 1 To attach End cap:
1) Place plastic end cap over exposed rear roller area.
2) Align holes in plastic end cap with pre-drilled holes in frame.
3) Loosely tighten each screw until all four screws are lined up.
4) Tighten all four screws snugly.
Figure 2 Assembly for main uprights
1) Raise the console into an upright position. Loosely install both 3/4” buttonhead screws on each side of the
upright. Install and tighten each 3 1/2” x 5/16” bolt (2) with washers from the bottom of the base frame
through the upright lock (diag. 1).
2) Now tighten the buttonhead screws securely from step 1.
3) Install motor hood cover using 5/8” phillips head screws (8 screws).
Be sure the treadmill is level to the floor. The rear feet can be adjusted to level the treadmill.
Assembly is now complete!
7
Figure 1
Figure 2
Assembly Instructions
