The ALL900 is shipped in two pieces, and the ALL920-OB is shipped in four pieces, please see assembly instruc-
tions below. After opening the box, remove any packing materials from the treadmill. Do not throw away any
packing materials until the unit is working properly. Place the base on a clean, level surface. Make sure the electri-
cal cord will easily reach an electrical outlet.
Figure 1 To attach End cap: For the ALL900
1) Place plastic end cap over exposed rear roller area.
2) Align holes in plastic end cap with pre-drilled holes in frame.
3) Loosely tighten each screw until all four screws are lined up.
4) Tighten all four screws snugly.
Figure 2 Assembly for main uprights For the ALL920OB
1)Raise the console into an upright position. Loosely install both 3/4” buttonhead screws on each side of the
upright. Install and tighten each 3 1/2” x 5/16” bolt (2) with washers from the bottom of the base frame through
the upright lock (fig. 2).
2)Now tighten the buttonhead screws securely from step 1.
3)Install motor hood cover using 5/8” phillips head screws (8 screws).
Be sure the treadmill is level to the floor. The rear feet can be adjusted to level the treadmill.
Assembly is now complete!
Moving
For the ALL900 only
CAUTION! TO AVOID THE RISK OF INJURY, NEVER ATTEMPT TO MOVE THE TREADMILL WHILE IT IS IN THE
UNFOLDED OPERATING POSITON. TO REDUCE THE POSSIBILITY OF INJURY WHILE LIFTING, BEND YOUR LEGS
AND KEEP YOUR BACK STRAIGHT. AS YOU RAISE THE TREADMILL, LIFT USING YOUR LEGS, NOT YOUR BACK.
IN ORDER TO RAISE OR LOWER THE TREADMILL SAFELY, YOU MUST BE ABLE TO LIFT 45 POUNDS (20KG). IT IS
SUGGESTED YOU ALWAYS USE THE AID OF A SECOND PERSON WHEN MOVING THE TREADMILL.
With the treadmill in the folded locked position (safety latch is engaged), grasp the handrails and place one foot on the base as
shown in the photo below. Next, with a firm grasp on handrails, place one foot on the center of the base crossbar and carefully tilt
the treadmill back until it rolls freely on the wheels. Using extreme caution, move the treadmill to the desired location. To set the
treadmill down, place one foot on the center of the base crossbar and carefully lower treadmill onto base in resting position. Do not
attempt to move the treadmill over an uneven or rough surface.
7
Figure 1
Figure 2
Assembly Instructions
