KEYBOARDPARTNER HX3 Drawbar Controller, Руководство пользователя

Страница: 6 / 27

6 HX3 Drawbar Expander
Controls
The HX3 Drawbar Expander has the typical controls of a classic tonewheel organ: two sets of
drawbars for shaping the organ sound, three bass-pedal drawbars, buttons for effects. The
VOLUME knob adjusts the overall volume of all 4 audio outputs.
The left drawbar set acts like the original on the upper manual, the left on the lower manual. For
the pedal, in addition to the drawbars for 16 'and 8' a drawbar for the pedal sustain ("Sustain")
exists.
Instead of rocker switches, the HX3 expander
has easy-to-use buttons, which can also display
the settings called up via presets. The rotary
switch for vibrato setting has also been replaced
by three buttons. Another button switches from
vibrato to chorus setting.

PERCUSSION ON toggles percussion on/off. When on, drawbar
1’ is cancelled (see
No DB1
@Perc parameter below to change cancelling behaviour). Percussion is not sounding with
each keystroke, but rather if all keys have been released before.

PERCUSSION SOFT toggles normal/soft percussion. Drawbar volume is muted in normal
position to emphasize percussion. Muting level may be changed by menu.

PERCUSSION FAST toggles slow/fast percussion decay between approx. 1 second and 0.2
second.

PERCUSSION THIRD toggles 2
nd
and 3
rd
percussion harmonic. No function in H100 mode.

VIBRATO offers three settings V1 to V3 (or C1 to C3 when the CHORUS button is pressed).
Vibrato / Chorus is only active when switched to the upper or lower manual.

VIBRATO UPPER toggles vibrato on upper manual on/off

VIBRATO LOWER toggles vibrato on lower manual on/off.

ROTARY RUN toggles rotary motors on/off. Rotary buttons control both internal rotary
simulation as well as a Leslie® speaker connected to 11-pin socket simultaneously. Amp and
speaker modeling remains active even if the motors are off. So this is no a bypass function.
Rotary simulation may be controlled by footswitch or panel buttons alternatively.

ROTARY SPEED toggles slow/fast rotary speed. A flashing LED indicates rotary speed.

REVERB I and REVERB II select 3 different reverb settings and reverb off. Press I and II
simultaneously to select reverb III. Reverb is not applied to the separate bass pedal sound.

CONFIG A/B switches the equalizer on and off. (Default configuration. This button may be
assigned deliberately with the HX3.5 Editor.).

SPLIT elects the pedal signal insert point before or after the preamp simulation. In many cases
it is desirable to limit the overdrive effect to the manuals.