Key Digital KD-VW4x4ProK, Руководство пользователя

Страница: 5 / 36

521 East 3
rd
Street Mt. Vernon, NY 10553 • www.keydigital.com
Rev 1.0
– Jul, 2022
5
Quick Setup Guide
Begin with the KD-VW4x4ProK and KD-EXMLVRx units, all source, display devices, audio system, and
any other connected peripherals powered off.
Connect
1. Connect video sources into the HDMI input ports
2. Connect video displays to the HDMI output ports on the main and/or Rx units
3. Connect CAT6 cabling
from the main unit’s UHDoTP outputs to the RX unit’s UHDoTP input
4. Connect audio using the digital or analog outputs ports located on the main unit.
5. Connect Control System . For KD-App control and/or IP control from a control system or PC, connect
TCP/IP port to network. RS-232 and IR control may also be utilized
6. (Optional) Connect IR to / from Rx units
a. If controlling displays: Connect from control system into IR In/Out ports of main unit and
connect IR emitter to the IR Out port of the respective Rx unit (1
→ 1 … 4 →
4).
b. If controlling video source: Connect IR sensor to Rx unit to collect line-of-site IR from a
remote. Connect IR emitter to the respective IR In/Out port of main unit (1
→ 1 … 4 →
4).
7. Connect power. Screw-in power supply to the KD-VW4x4ProK unit, and then connect power to outlets.
8. Power on sources, displays, and audio systems to begin use.
Configure
Configure KD-VW4x4ProK with Key Digital Management Software Pro (KDMS Pro). Download HERE
1. Connect to KD-VW4x4ProK from your PC using the USB micro port on the face of the unit
2. Open the KDMS Pro software and perform a USB scan (2a)
. Choose “NO” and Start Scan when the
USB Device Scan prompt appears (2b)
3. Choose the detected device from the Devices window (fig. 3)
4. Enter the desired unit name (4a), IP address (4b) and IP gateway (4c) settings for the unit
5. Save (5)
6. Select the desired EDID handshake for each video source (6)
7. Enter the desired Input and Output names and press Update Names
8. (Optional) Use the Output Settings section to set the video output format for 4K to 1080p down-convert,
establish IR signal flow (default is IR In on the KD-VW4x4Pro4K and IR out on the Rx units to control),
and to choose a test pattern for outputting on your display if desired.