Kettler KB142-ZXRW, Перевод оригинальной инструкции по эксплуатации

Страница: 49 / 154

MY21K01 - 32_1.0_23.09.2020
49
Assembly
Setting the quick releases
Figure 63: Structure of quick release from rear with (1)
axle nut lock and (5) axle nut
1 Record the axle setting value (4) indicated by
the directional arrow (3).
2 Loosen the axle nut securing screw (2) with a
2.5 mm hex key by approx. four revolutions,
but do not remove the screw completely.
3 Turn the quick release lever to the open
position and loosen the axle by approx. four
revolutions.
4 Press the axle inward from the side of the open
lever. This pushes out the axle nut securing
screw so that you can turn it out of the way.
5 Push the axle further forward and turn the axle
nut clockwise to increase the lever tension or
anti-clockwise to reduce the lever tension.
6 Reinsert the axle nut lock and tighten the screw
to 0.9 Nm (8 in-lb).
7 Repeat the steps for installing the axle to check
proper installation and correct adjustment.
5.4.2.2 Kabolt axle
Only applies to FOX forks with Kabolt axles
The same procedure is used for installing both the
15 x 100 mm and 15 x 110 mm Kabolt axles.
1 Place the front wheel in the fork ends of the
fork. Push the Kabolt axle through the fork end
on the non-drive side and hub.
Figure 64: Pushing the Kabolt axle in
2 Tighten the Kabolt axle screw to 17 Nm
(150 in-lb) with a 6 mm hex key.
5.4.3 Checking the stem and handlebars
5.4.3.1 Checking the connections
1 Stand in front of the pedelec to check whether
the handlebars, stem and fork steerer are
firmly attached to one another. Clamp the front
wheel between your legs. Grasp the handlebar
grips.
2 Try to twist the handlebars towards the front
wheel.
 The stem must not move or twist.
1
2
3
4
5