EN
LED
Green
(1)
rot
(2)
Orange
(3)
orange
(4)/(5)
Acoustic
signal
(interval)
PFC
1
Description
Measure
Yes
Alarm level exceeded
Wait until the level drops
below the alarm level again
-
-
Maximum switch-
ing cycles exceeded
Acknowledge alarm
and replace control unit
1
Potential-free contact is activated (Art.No. 80074 must have been activated and connected beforehand)
2
The battery monitoring is only active if a battery was connected at the time of commissioning.
3
If the error re-occurs, contact customer service
Acknowledge alarm
If a condition arises that triggers an alarm, this will be indi-
cated through the illumination of the alarm LED (2) and, if
applicable, one of the other LEDs. After rectifying the cause
of the alarm, the alarm can be acknowledged by pressing the
button (7).
Switching off the alarm tone
Press button (7) 1x
Acknowledge alarm
Press and hold button (7) > 3 seconds.
The alarm indicator goes out, the alarm is acknowledged.
7.2.4
Manual operation
(4)
Manual operation LED
84 / 144
Pumping station / Installation and operating manual
016-102_05
Содержание Aquapump Small
