UBS Hydro II
Safety
EN
2018-05-02
19 / 60
Electronic components
Electronic components may contain poisonous substances. They must not get to
the environment. The disposal has to be done by a professional disposal company.
Accumulators and batteries
Rechargeable batteries contain toxic heavy metals. They are subject to special
treatment and must be returned to municipal collection points or disposed of by a
specialist.
2.10 Safety instructions for maintenance / trouble shooting
Conduct in case of dangerous faults
The following applies:
1.
Initiate the emergency stop immediately in case of faults that represent an
immediate risk for persons or objects.
2.
Determine the cause of fault.
3.
In case rectification of the fault requires work to be done in the danger zone,
switch off the machine and secure it against a restart.
4.
Depending upon the type of fault, get it rectified by authorized specialist
personnel or rectify it yourself.
DANGER
Risk to life or risk of injury due to improperly carried out maintenance work
/ trouble shooting!
Maintenance work / trouble shooting conducted improperly causes danger to life
or risk of injury, as well as risk of material damages to the machine or system!
•
Observe all safety instructions in this chapter as well as the applicable
local safety and accident prevention regulations
•
Malfunctions, which require an intervention, as well as maintenance and
cleaning works, should be rectified only when it is ensured that the
machine is at a standstill and is safeguarded against a restart.
•
Release the blockages only when it is ensured that removing them will not
result in any dangerous movements of machine parts.
•
Ensure adequate freedom of movement before starting the work.
•
Pay attention to order and cleanliness at the assembly place! Parts lying
around loose or one above the other are sources of accidents.
- If components have been removed, pay attention to correct assembly,
reassemble all fixing elements.
•
Pay attention to the following before a restart:
•
Make sure that all works have been done and completed according to the
instructions and information given in these Operating Instructions.
•
Ensure that no persons are present in the danger zone.
•
Make sure that all coverings and safety devices are installed and are
working properly.
•
Wait until the oil has cooled down below 50 °C, before starting works
•
Before starting works, make a temperature-resistant collecting container
with the necessary capacity available.