UBS Hydro II
Safety
EN
2018-05-02
15 / 60
In an emergency, immediately release the two handles of the operating unit. With
this, the dead man lever (3) triggers.
•
The one-axle host vehicle stops
•
The drive to the attachment is interrupted
•
The engine will NOT be switched off and continues running
Before moving off, perform the following steps!
•
Drive lever (1, 2) must be in horizontal position.
•
The lever for the auxilia
ry drive (5) must be switched in the „Off“ position.
•
Push the dead man lever (3) down.
If only one of the before mentioned conditions is not fulfilled, moving off / switching
on of the auxiliary drive will NOT be possible despite of the actuation of the dead
man lever (3).
2.7
Safety signage
The following symbols and indicating labels are in the work area. They refer to the
immediate vicinity where they are attached.
WARNING
Risk of injury due to illegible or missing signage!
Missing or illegible Labels and signs can lead to severe health impairment and
potential life-threatening injuries.
•
Keep all safety, warning and operating indications al-ways in a good legible
state.
•
Exchange immediately damaged signs and stickers.
2.8
Residual risk
The machine is designed according to the state of the art and the actual safety
requirements. However, there are still residual risks that require cautious acting.
The residual risks and the corresponding behavior and measures are listed below.
Improper transportation
NOTE
Material damages due to improper transportation
Pieces been transported can fall or tumble if transported improperly. This can
cause considerable material damages.
•
Work carefully when unloading the transport pieces upon delivery as well
as when transporting within the factory and pay attention to the symbols
and instructions on the packaging.
•
Use only the attachment points provided.
•
Remove the packaging only just before assembly.
