22
Maintenance
10
Maintenance
10.1 General maintenance instructions
•
Personal injury or damage to the machine may occur.
•
Check all safety-related parts before every use of the machine.
•
Oil change intervals must be carried out according to the recommendations of the respective engine
manufacturer.
•
Check the hydraulic connections for leaks before each use.
•
High pressure leaking fluids (such as hydraulic oil and diesel fuel) can penetrate the
skin and cause serious injury! Therefore, seek medical attention immediately - risk of
infection!
•
The self-propelled implement is powered by biodegradable oil.
•
The machine must be regularly serviced.
•
Dispose of oils, fuels and filters separately and properly!
•
When working on the electrical system, disconnect the earth connection from the battery!
•
Repairs, maintenance and cleaning work as well as the elimination of malfunctions must always be
carried out with the drive switched off and the engine stationary. Remove ignition key or spark plug
connector! After carrying out this work, replace all protective devices!
•
If the machine is transported in a different way than with its own drive, this must be done with the motor
switched off!
•
Regularly check nuts and bolts for tightness and retighten if necessary.
•
When carrying out electrical welding work on the tractor and attached equipment, disconnect the cables
at the generator and at the battery!
•
Only use original spare parts from the manufacturer!
•
After the first 5 hours of operation, check all screw and bolt connections.
•
Lubricate or lubricate all moving parts regularly.
•
Check hydraulic connections for the first time after 5 operating hours, retighten if necessary.
Only tightening has no success!
Release a leaking hydraulic fitting first, then move the hose or fitting, and then
retighten the fitting.
10.2 Daily maintenance
•
Before each use, the safety elements and moving parts must be checked for wear.
•
Check the hydraulic oil level before each use. To do this, unscrew the cap from the tank and visually
check whether the oil in the tank easily covers the horizontally arranged plate.
•
Below the device holder of the self-propelled implement, there is a grease nipple, which is greased
before each use.
•
Check the engine oil level before each use.
•
Inspect the air pre-filter (if present) and air filter cartridge for dirt if it is very dirty or damaged.
•
Check hydraulic connections and lines for leaks and damage.
•
Check the air pressure of the drive wheels.
•
Carry out a test run before each use.
•
Clean the unit after each use.
•
Check oil cooler for dirt and clean if necessary.
