KEPCO ATE 100-10DMG, Руководство оператора

Страница: 95 / 98

ATE-DMG 020613
B-21
TABLE B-4. ERROR MESSAGES
ERROR MESSAGE
ESR ERROR BIT SET
(SEE PAR. A.5)
EXPLANATION
0,“No error”
None No error.
-100,“Command error”
Command Error bit 5
Command and data understood, but more informa-
tion included which is not recognized.
-102,”Syntax error”
Command Error bit 5
First 4 characters recognized, subsequent charac-
ters not recognized.
-103,”Invalid separator”
Command Error bit 5
For example, VOLT.PROT received instead of
VOLT:PROT.
-108,”Parameter Not Allowed Error”
Command Error bit 5 Volt12 sequence, channel number is invalid.
-109,”Missing parameter”
Command Error bit 5 For example, VOLT instead of VOLT 21.
-111,”Header separator error”
Command Error bit 5 Missing space between volt and value or ; missing.
-113,”Undefined header”
Command Error bit 5
First 4 characters could not be identified as legal
command.For example, command VLT instead of
VOLT.
-120,”Numeric data error”
Command Error bit 5
Expected number but other characters were
detected.
-121,”Invalid character in number”
Command Error bit 5 Volt 1,500 (comma not allowed).
-123,”Exponent too large”
Command Error bit 5 Exponent E+3 or greater is invalid.
-141,”Invalid character data”
Command Error bit 5
For example OUTP OFD or OUTP STOP instead of
OUTP OFF.
-150,”String data error”
Command Error bit 5
Invalid characters were detected in numeric entry.
For example E.1 instead of E+1 or 4d3 instead of
4.3.
-203,”Command protected”
Execution error bit 4 Command only valid in password Cenable state.
-221,”Settings conflict”
Execution error bit 4 Invalid password from syst:pass:cen command.
-222,“Data out of range”
Execution error bit 4 Value exceeds power supply rating.
-223,”Data format error”
Execution error bit 4 Multiple decimals in digit, Multiple E, etc.
-224,“Illegal parameter value”
Execution error bit 4 For example, OUTP 2 instead of OUTP 1.
-241,”Hardware missing”
Execution error bit 4 Requesting device 2 status (INST:NSEL 2).
-282,”Illegal program name”
Execution error bit 4 Executing prog:run without LIST:SEQ command.
-301,”Value bigger than limit”
Device Error bit 3 Requesting a time of 301 which is bigger than limit.
-311,”Memory error”
Device Error bit 3 Power-up NV RAM error.
-314,”Save/recall memory error”
Device Error bit 3 Using cell other than 1 - 41 for SAV and RCL.
-341,”Non Volatile Mem. CRC error”
Device Error bit 3
Power supply constants may be corrupted; recali-
bration may be necessary.
-350, “Queue overflow”
Query Error bit 2 More than 15 errors are in queue.
-410,”Query interrupted”
Query Error bit 2
New command sent before data from previous
query read. Previous query data lost.
-430, “Query Deadlocked”
Query Error bit 2 Over 255 characters received in single input string.