KEPCO ATE 100-10DMG, Руководство оператора

Страница: 52 / 98

3-18
ATE-DMG 020613
3.5 ANALOG REMOTE PROGRAMMING
The ATE-DMG has the capability to control the output using external d-c analog reference volt-
ages. Analog references for both voltage and current are required to produce an output. Two
uncommitted amplifiers (preamps ”A” and “B”) included in the unit can be used for signal condi-
tioning. Each preamp has an inverting input (–), non-inverting input (+), and output, and a zero
adjustment, the preamps are accessible via A11J5 pins as shown in Figures 2-3 and 3-7 and
listed in Table 3-4. To gain access to A11J5, loosen two screws at the rear panel and disconnect
interconnection adapter A11, then remove two screws securing connector A11J1 to the shell.
FIGURE 3-7. A11 ASSEMBLY CONNECTOR AND PIN LOCATIONS
(For further details about Preamp “A” and “B” go to www.kepcopower.com/support and down-
load the Operator manual for ATE 1/4 Rack, 1/2 Rack 3/4 Rack or Full Rack, and refer to PAR’s
3-37 through 3-84.)
Connections to A11J5 can be made via discrete wires, a flat ribbon cable not exceeding 1 foot in
length or by discrete wires terminated into crimp style pins inserted into a 5x2 housing (not sup-
plied). The following parts are recommended, but not supplied: ribbon cable: AMP 746285-1
(Kepco P/N 142-0246); Housing for discrete wires: Molex 39-01-2100 (Kepco P/N 142-0434);
Pins: Molex 39-00-0039 (Kepco P/N 107-0290, 4 ea.).
NOTE: When making connections to A11J5, move unused jumper to a single pin of connector
J3 (DO NOT SHORT J3 PINS).
TABLE 3-4. CONNECTOR A11J5 PIN FUNCTIONS
PIN FUNCTION PIN FUNCTION
1 VEXT 6 GND
2 CEXT 7 PREAMP “B” IN (+)
3 PREAMP “A” OUT 8 GND
4 PREAMP “A” IN (–) 9 PREAMP “B” IN (–)
5 PREAMP “A” IN (+) 10 PREAMP “B” OUT