STEP #4
Installing the Cooktop
Once the cutout has been prepared as shown on page 3, pre-fit the stove into the cutout to mark
drill locations. Tilt and insert the front portion of the stove first. Care should be exercised so as
not to damage or bend any moving parts. Next, lower the stove into the cut out. Using a pencil
mark the location of mounting holes onto the counter. Carefully remove the stove from the
cutout. Using a 1/8” drill and the pencil marks as a guide, drill four (4) mounting holes. Replace
the stove into the counter. Mount the stove in place by using (4) #8 x 5/8” oval head stainless
steel wood screws (not supplied).
STEP #5
Electrical Connection
It is recommended that the supply conductors be protected with a double pole simultaneous trip
circuit breaker per the specifications for the various models and voltages as shown in the
Electrical Requirements Table on page 5. Use SO rubber-insulated cable to connect the boat
shore power electrical circuit to the terminal board behind the stove.
NOTE: ONLY QUALIFIED INSTALLERS SHOULD CONNECT THIS APPLIANCE TO THE
ELECTRICAL SERVICE.
Remove the back cover on the stove; push the cable through 7/8” (22 mm) hole below the
terminal board, using the black plastic grommet to protect the supply cable. Connect the
ungrounded current carrying conductor to terminal marked L1. Connect the other ungrounded
current carrying conductor for 240V units or neutral carrying conductor for 120V units to the
terminal marked L2. Connect the ground wire (green) to the left terminal marked G. A cable
clamp is provided to secure cable. Replace the back cover after all connections have been
made.
STEP #6
Final Preparations Prior to Use
Remove any protective or packaging material from the cooktop. Clean the cooktop before you
use it for the first time.
The next section of the manual covers cooktop use, maintenance and service information.
Please keep these instructions with the
KENYON cooktop for future reference.
7
