Kenwood TS-990S, Инструкция по эксплуатации

Страница: 236 / 290

16 USEFUL FUNCTIONS
16-4
Index Contents
RESET
The configuration data stored in the transceiver can easily
be saved in other memory devices. Additionally, to delete
the operating data stored in the transceiver memory and
to store new operating data, you can select the intended
reset from the five reset types.
• Menu Reset: Resets all parameters on the Menu screen to
their defaults.
• Memory Channel Reset: Resets the configuration data for the
memory channels and quick memory channels.
• VFO Reset: Resets all operating data in the VFO.
• Standard Reset: Reset all operating data except the
configuration data for the Clock, Transmit Power Limiter, and
TX Inhibit.
• Full Reset: Resets all configuration data in the transceiver to
their defaults.
Note:
◆ The configuration data for memory channels, quick memory
channels, all data on the menu, preset values for the antenna tuner,
auto-mode frequency data, and various levels will not be reset.
◆ Once any reset begins, the data will be cleared. You must reset the
transceiver after the configuration data has been stored in another
storage device.
◆ In Menu 1-06, the default for Automatic Voice Guidance is
"Off". Activating any reset other than Memory Channel Reset
and VFO Reset will reset Menu 1-06 to the default; hence, the
transceiver does not do any voice guidance by Automatic Voice
Guidance. {page 14-2}
[F1]~[F7]
[MENU]
F[RESET]
Follow the procedure below to reset the transceiver.
1 Press [RESET] (F) on the Menu screen to open the
Reset screen.
2 Press [ ] (F2) or [ ] (F3), or rotate the
MULTI/CH control to select a reset type.
Press [MENU TOP] (F) to close the Reset Configuration
Data screen and display the Menu screen.
3 Press [SELECT] (F4).
• A message prompting the start of the reset appears.
• Pressing [CANCEL] (F4) does not start the resetting
process and closes a message that prompted you to start
the resetting process.
4 Press [RESET] (F4).
The transceiver is reset and automatically restarts.
SELECTING THE OPERATING BAND FOR THE
HI/SHIFT LO/WIDTH CONTROLS
Using the HI/SHIFT LO/WIDTH control, you can adjust
the cutoff frequencies (low and high) and the passband
width and shift. You can configure whether to adjust the
main band or both the main band and the sub band.
1 Select Group No. 0, "Basic Configurations", from the
Menu screen.
2 Access Menu 14, "Operating Band (High/ Low & Shift/
Width Controls)".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select "Main and sub
bands" or "Main Band only".
The default is "Main and sub bands".
5 Press [ ] (F1).
6 Press [MENU] to exit.
Note:
◆ If "Main Band only" is selected, the "SUB" LED on the right of
the HI/SHIFT LO/WIDTH controls does not light. In this
case, rotating the HI/SHIFT LO/WIDTH controls increases or
decreases the value for the HI/SHIFT and LO/WIDTH.