Kenwood TS-990S, Инструкция по эксплуатации

Страница: 120 / 290

5-42
5 ASSISTING YOUR SMOOTH QSO
Index Contents
CONFIGURING THE AUTOMATIC
TRANSMISSION AND RECEPTION USING THE
RTTY MESSAGE MEMORY
You can transmit messages entered in the RTTY message
memory.
[F1]~[F7]
[FSK/PSK/REV]
1 Press [FSK/ PSK/ REV] to enter RTTY (FSK) mode.
2 Press [DECODER] (F3) to open the RTTY Encode/
Decode screen.
3 Press [MEMORY] (F5) to open the RTTY Message
screen.
4 Press [CH1] (F3), [CH2] (F4), [CH3] (F5), [CH4] (F6),
[CH5] (F3), [CH6] (F4), [CH7] (F5), or [CH8] (F6) to
select the channel for which the message to be sent
has been stored.
• The RTTY message in the channel corresponding to
the function key is transmitted automatically. The RTTY
message will not automatically be transmitted from the
channel for which automatic transmission is disabled.
• The key guide for [F1] through [F7] are the key guide for
configuration, including [ ] (F1), [MORE] (F2),
[ ] (F3), [ ] (F4), [MSG] (F5), [AUTO.TX]
(F6), and [AUTO.RX] (F7). In this case, press [MORE] (F2)
so that the key guide will alternate between the key guide
for [ ] (F1), [MORE] (F2), [CH1] (F3), [CH2] (F4),
[CH3] (F5), [CH4] (F6), and [NEXT] (F7) and the key guide
for [ ] (F1), [MORE] (F2), [CH5] (F3), [CH6] (F4),
[CH7] (F5), [CH8] (F6), and [NEXT] (F7).
• The transceiver enters the receive mode after the RTTY
message displayed along with "AUTO RX" on the right
side.
CONFIGURATION FOR RTTY ENCODING AND
DECODING
ENABLING THE UOS (UNSHIFT ON SPACE)
If the received RTTY signal contains a space, use this
function to decode the letter next to the space forcibly as a
letter code (alphabetical letter).
In RTTY, the influence of signal strength or noise causes
letter corruption. In order to avoid this problem as much
as possible, the function makes it possible to decode the
letter after the space as a more frequently used letter code
(alphabetical letter).
To receive a test string containing numbers andsymbols
subsequent to a space, you can disable the UOS function.
[F1]~[F7]
[MENU] [MULTI/CH]
1 Select Group No. 2, "Decoding & Encoding", from the
Menu screen.
2 Access Menu 01, "RX UOS".
3 Press [SELECT] (F4) to allow editing of the parameter
box.
4 Press [-] (F4) or [+] (F5) to select "On" or "Off".
The default is "On" (encoding a blank letter). Selecting "Off"
does not allow the transceiver to encode the blank letter.
5 Press [ ] (F1).
6 Press [MENU] to exit.