hints
●
To make a thinner smoothie drink
add more liquid.
●
To make a thicker smoothie drink
add more frozen ingredients.
●
Before fitting the lid, push the solid
ingredients into the liquid using the
stirrer.
●
Use the pulse ‘P’ button to operate
the power unit in a start stop action
to control the texture of your drink.
Take care as this automatically
selects the higher speed and may
cause the drink to be thrown up the
sides and onto the lid of the goblet.
●
After blending, some drinks may not
be completely smooth due to seeds
or the fibrous nature of ingredients.
●
Some drinks may separate on
standing, therefore, it’s best to drink
them straight away. Separated
drinks should be stirred before
drinking.
important
●
Never blend more than the
maximum capacity of 1500ml
marked on the goblet.
●
Never blend dry ingredients (eg
spices, nuts) or run the Smoothie
Blender empty.
●
Don’t use the Smoothie Blender as
a storage container. Keep it empty
before and after use.
●
Some liquids increase in volume and
froth during blending eg milk, so do
not overfill and ensure the lid is
correctly fitted.
●
To ensure long life of your Smoothie
Blender, never run it continuously for
longer than 60 seconds.
●
Never blend food that has formed a
solid mass during freezing, break it
up before adding to the goblet.
care & cleaning
●
Always switch off, unplug and
dismantle before cleaning.
●
Never let the power unit, cord or
plug get wet.
●
Empty the goblet before unscrewing
the blade unit.
●
Always wash immediately after use.
Don’t let food dry onto the goblet
assembly as this will make cleaning
difficult.
●
Don’t wash any part in the
dishwasher.
●
Regularly dismantle the tap and
clean the parts thoroughly.
Smoothie Blender unit
Before dismantling the Smoothie
Blender, half fill the goblet with warm
water. Fit the lid and stirrer then
place on the power unit. Switch to
low ‘ ’ and whilst running open the
tap and allow the water to drain into
a container to clean the valve. This
can be repeated until the water runs
clear. If further cleaning is necessary
dismantle the unit first.
power unit
●
Wipe with a damp cloth, then dry.
●
Push excess cord into the back of
the power unit.
blade unit
1 Remove and wash the sealing ring.
2 Don’t touch the sharp blades - brush
them clean using hot soapy water,
then rinse thoroughly under the tap.
Don’t immerse the blade assembly in
water.
3 Leave to dry upside down away from
children.
goblet, lid, cap and stirrer
Wash by hand, rinse with clean
water then dry.
cleaning the tap
Remove the tap assembly from the
goblet, then soak the tap in hot
soapy water with the valve open
.
Wash thoroughly then rinse and dry.
Wash and dry the goblet then refit
the tap ensuring that the seal is
correctly positioned on the goblet
.
dismantling the tap
1 Unscrew the tap lever from the tap
body
.
Do not remove the
clear plastic cover from the
assembly.
4
