Kenwood sb300 series, Инструкция по эксплуатации

Страница: 7 / 10

●
Use the PULSE button to operate
the power unit in a start stop action
to control the texture of your drink.
Take care as this automatically
selects the higher speed and may
cause the drink to be thrown up the
sides and onto the lid of the goblet.
●
After blending, some drinks may not
be completely smooth due to seeds
or the fibrous nature of ingredients.
●
Some drinks may separate on
standing, therefore it’s best to drink
them straight away. Separated
drinks should be stirred before
drinking.
important
●
Never blend dry ingredients (eg
spices, nuts) or run the Smoothie
Blender empty.
●
Don’t use the blender as a storage
container. Keep it empty before and
after use.
●
Some liquids increase in volume and
froth during blending eg milk, so do
not overfill and ensure the lid is
correctly fitted.
●
To ensure long life of your Smoothie
Blender, never run it continuously for
longer than 60 seconds.
●
Never blend food that has formed a
solid mass during freezing, break it
up before adding to the goblet.
cleaning
●
Always switch off, unplug and
dismantle before cleaning.
●
Never let the power unit, cord or
plug get wet.
●
Empty the goblet before unscrewing
it from the blade unit.
●
Always wash immediately after use.
Don’t let food dry onto the goblet
assembly as this will make cleaning
difficult.
●
Don’t wash any part in the
dishwasher.
●
Regularly dismantle the tap and
clean the parts thoroughly.
blender unit
Before dismantling the blender, half
fill the goblet with warm water. Fit the
lid and cap then place on the power
unit. Switch to MIX and whilst
running open the tap and allow the
water to drain into a container to
clean the valve. This can be
repeated until the water runs clear. If
further cleaning is necessary
dismantle the unit first.
power unit
●
Wipe with a damp cloth, then dry.
blade unit
1 Remove and wash the sealing ring.
2 Don’t touch the sharp blades - brush
them clean using hot soapy water,
then rinse thoroughly under the tap.
Don’t immerse the blade assembly in
water.
3 Leave to dry upside down away from
children.
lid, cap, stirrer
Wash by hand, rinse with clean
water then dry.
cleaning the tap
Remove the tap assembly from the
goblet, then soak the tap in hot
soapy water with the valve open
.
Wash thoroughly then rinse and dry.
Wash and dry the goblet then refit
the tap ensuring that the seals are
correctly positioned on the goblet
.
dismantling the tap
1 Unscrew the cap .
2 Push up on the plug and remove
the lever.
3 Remove the plug and spring .
4 Wash all the components, then dry
thoroughly.
5 Reassemble the unit by reversing the
above procedure .
4